Silvercrest SUSR 17 A1 Service Manual download pdf (Page 104)

SilverCrest SWR 300 A1

102 - English

Troubleshooting

The Power LED (1) does not light up.

 Socket defective or fuse tripped; check the socket with another device.

The configuration menu of the wireless repeater is not shown.

 The IP address http://192.168.10.1 was entered into the address line of the Internet browser

incorrectly; check and correct the entry.

 The wireless repeater has already been configured and is using another IP address. To be able to

establish a connection to the wireless repeater, the IP address of your computer must be

changed. Proceed as follows:

 Turn on your computer.



Click on Start | Control Panel | View network status and tasks | LAN

connection | Properties | Internet Protocol Version 4 (TCP/IPv4) | Properties.

 Now select Use the following IP

address and enter an IP address

between 192.168.10.100 and

192.168.10.200 (for example,

192.168.10.101). Now enter the IP

address 255.255.255.0 under

Subnet Mask and click on OK.

 Then close all opened windows.

 The wireless repeater has already been configured and is using another IP address. Reset the

wireless repeater to the factory default settings. Hold down the reset button (7) for at least 10

seconds until the LEDs briefly go out and then come on again.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 110 111 112

No comments

Silvercrest SUSR 17 A1 Service Manual Page 104