Silvercrest BABYTALKER 1030 User Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 108
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
13
Babytalker 1030
ENGLISH
11.4.4 Charging batteries in the parents' unit
- Connect the power adapter (7.5 V 300 mA)
to a mains socket (230-240 V~ 50 Hz).
- The flashing battery charge indicator in the display
shows that the batteries are being charged:
12 Operating the device
12.1 Switching the parents' unit and baby unit on and off
- Press the On/Off button to switch on the parents' unit. The display illuminates.
- To switch on the baby unit, press the On/Off button . The display illuminates.
- To switch off the parents' unit, press and hold the On/Off button until the display goes out.
- To switch off the baby unit, press and hold the On/Off button until the display goes out.
12.2 Setting the channel
To have communication between the baby unit and the parents’ unit they both need to be set on the same
channel.
- Press the channel up or channel down button on the parents' unit to select the channel
on the parents' unit.
- Press the channel up or channel down button on the baby unit to select the same
channel as on the parents' unit.
Once both units are set to the same channel, the parents’ unit can receive the signal from the baby unit.
When on one or both units is displayed, the privacy mode is activated.
See section "12.3 Activating privacy mode"
The batteries take about 12 hours
to charge.
The batteries are charged continuously.
Therefore the flashing battery charge
indicator in the display is still visible even
when the batteries are fully charged.
Before setting the channel (see section "12.2 Setting the channel") and/or
activating/deactivating privacy mode (see section "12.3 Activating privacy mode"),
make sure that the VOX sensitivity switch on the baby unit has been turned
clockwise (lowest level). Also make sure that you configure the settings on the
baby unit in a quiet environment.
- The reason for this is that the baby unit starts transmitting as soon as the
microphone picks up a sound. You cannot change the settings on the baby unit
while it is transmitting (TX is shown in the LCD display on the baby unit).
9
18
14
9
18
24
3
4
15
16
HL_Babytalker 1030_LB4.book Page 13 Wednesday, March 16, 2011 10:06 PM
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 107 108

Comments to this Manuals

No comments