Silvercrest SLB 450 A2 User Manual download pdf (Page 11)

Setting up and connecting

SLB 450 A2

Electrical connections

IMPORTANT

Before you connect up, compare the connection data (voltage and fre- ►

quency) on the plate of the appliance with that of your electrical network.

This data must match in order to av

oid damage to the appliance.

Check to ensure that the power cable ►

of the appliance is undamaged

and it will not be laid over hot surfaces and/or sharp edges.

Make sure that the power cable ►

is not over taut or folded.

Do not let the power cable ►

hang over edges (trip wire eﬀ ect).

Inserting batteries into the remote control

To insert a new battery, proceed as follows:

Open the battery compartment at the rear of the remote control ♦

rotating the circular cover in the direction of the symbol

. Use a small

coin for turning it.

Insert a battery of the type CR 2032 (3V) into the battery compartment. ♦

Make sure the polarities are correct; the positive pole faces up.

Close the battery compartment b

y replacing the round cover and turning it ♦

in the direction of the symbol

until it is ﬁ rmly seated back in the housing.

Fixing the air-bubble mat into the bath

DANGER

Slippery!

If the air bubble mat is not ﬁ x

ed into the bathtub properly,

there is a great risk of slipping!

Observe the following safety information to avoid the risks of slipping:

Carefully press the air-bubble mat onto the bottom of the bath tub until all ►

of the suction cups on the air-bubble mat are ﬁ rmly secured to the bath

bottom.

Check ever

y time before getting into the bath tub whether the air-bubble ►

mat is still properly and ﬁ rmly secured.

Do not climb into the bathtub before all the suction cups of the air-bubble

►

mat are properly secured in the bath tub.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 121 122

No comments

Silvercrest SLB 450 A2 User Manual Page 11