Silvercrest Electrical Sockets User Manual download pdf (Page 4)

8 GB/IE

Safety / Setting up

J If the device malfunctions, switch it

oﬀ immediately.

J These instructions are a component

of the device. If you pass the device

on to a third party, these instructions

must also be handed on.

Q

Advice on use of dimmer

radio-controlled

socket

(FSD B 20-A)

Use the remote-controlled dimmer

socket FSD B 20-A only for the following

lamps:

– 240 V

~

light bulbs 20–280 W

– 240 V

~

high-voltage halogen bulbs

20–280 W

Do not use the dimmer / remote-controlled

electrical outlet socket for energy-saving

lamps, ﬂuorescent lamps, lamps with

their own dimmers and lamps with

transformers, except for incandescent

and halogen lamps with electronic

transformers (12 V / 20–50 W). Do not

use any other consumers. This may

damage the connected consumers and

the remote-controlled sockets.

Q

Setting up

Q

Preparing the remote

control (FSS B 20-A)

(ﬁg. A)

1. Open the battery compartment on

the back of the remote control by

pushing away the battery compart-

ment cover

4

downwards. Insert a

12 V battery. Make sure you ﬁt the

battery the right way round (polarity).

2. Press one of the ON / OFF buttons

2

or

3

to test whether the remote

control works; if it does, the power

indicator light will come on

1

.

Q

Setting up the remote-

controlled socket

(FSE B 20-A) (ﬁg. B)

1. Insert the remote-controlled socket

into an earthed household socket

and switch it on with the ON / OFF

switch

5

. The LED operating status

display

6

will come on.

2. Point the remote control at the remote-

controlled socket at a distance of

approx. 50 cm.

3. Press the LEARN button

7

of the

remote-controlled socket for ap-

prox. 3 seconds and release it

again. The LED operating status dis-

play

6

will ﬂash for approx. 10

seconds. While it is ﬂashing, press the

desired ON button of the channel

ON / OFF button

2

(A, B, C or D)

of the remote control. The LED op-

erating status display

6

will now

shine permanently. You can now

switch a connected consumer on or

oﬀ using the remote control.

4. Repeat this procedure with the other

remote-controlled socket.

5. You can switch several remote-con-

trolled sockets on and oﬀ at the

same time using the ON / OFF but-

66538_silv_Funkschaltset_Content_GB-IE.indd 8 29.06.11 11:45

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments