Silvercrest SHMSB 300 A2 User Manual download pdf (Page 33)

30

SHMSB 300 A2

GB

2) Push the whisks 8 or the kneading hooks 9

into the slots 7 until they click audibly into

place and are secure.

Always insert the kneading

hook 9 or the whisk 8

without the ring into the

intended slot on the appli-

ance (labelled with an icon).

Always insert the kneading

hook 9 or the whisk 8 with

the ring on the shaft into the

intended slot on the appli-

ance (labelled with an icon).

3) Insert the mains plug 4 into a mains power

socket.

4) To start operating the appliance, move the speed

switch 2 to the desired speed setting. You

can select between 5 speed settings and also

use the Turbo button 3 (see section “Speed

levels”).

5) Press the tool release button 1 to release the

whisks 8 or the kneading hooks 9.

NOTE

► For safety reasons, the whisks 8 and kneading

hook

s 9 can only be released if the speed

switch 2 is set to position "0".

Pureeing

WARNING! RISK OF INJURY!

► Never use containers made from glass or

other easily br

eakable materials. These con-

tainers may be damaged and cause injuries.

ATTENTION! DAMAGE TO PROPERTY!

► Never use the blender 0 for har

d foodstuﬀ s

such as: coﬀ ee beans, ice cubes, sugar,

cereals, chocolate, raw/hard vegetables etc.

This could result in serious damage to the

appliance.

1) Open the ﬁ xture with the safety cover 5 and

hold the safety cover ﬁ rmly.

NOTE

► The blender 0 can only be used if the

whisk

s 8 or the kneading hooks 9 are not

installed.

2) Push the blender 0 into the ﬁ xture 5, push

it down and tighten it by turning ﬁ rmly several

times in the direction of the arrow

.

3) To avoid overﬂ owing, the container used for

blending should only be ﬁ lled to about 2/3 of

its capacity. Select a suitably large container

or use the supplied measuring jug q.

NOTE

► In order to ensure that the ingredients are

pr

operly mixed, the food that is being pro-

cessed should cover at least the lower part

of the blender 0.

► Do not switch the hand mixer on until the

blender 0 has been inser

ted into the ingre-

dients to be blended.

4) Move the speed switch 2 to the “Blender”

setting

(see chapter “Speed levels”) and

press the Turbo button 3. Keep the Turbo

button 3 pressed down during the whole

procedure. The appliance stops as soon as it

is released.

ATTENTION! DAMAGE TO PROPERTY!

► Do not operate the blender 0 continuously

for longer than 1 minute. Af

ter one minute of

use, allow the appliance to cool down fully.

IB_109576_SHMSB300A2_LB1.indb 30 17.12.14 10:01

1 2 ... 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments