Silvercrest LT 710 User Manual download pdf (Page 17)

English SilverCrest LT 710

Using the Device

Powering the Device On/Off

Place the On/Off button (1) on the side panel must be put in ON position.

The device will power on in the last-used mode (DTV, TV or AV) and the

status indicator (7) will light green.

To power the device off at any time, press the button (14) on the remote

control. Then the device will enter Standby mode and the status indicator (7)

will light red. It is also possible to power the device back on from Standby

mode by pressing the button (14) on the remote control again.

To power the device off completely, place the On/Off button (1) on the side

panel in OFF position.

After the device has been powered off by using the On/Off

button (1) on the side panel it cannot be powered on via the

remote control.

Selecting the Input Source

Depending on the antenna or the external device that you have connected

you have to select the corresponding input source. To do so, press the

button DTV/ATV/AV (34) on the front of the device or the button

DTV/ATV/AV (15) on the remote control.

Each press of the button will toggle the input source cyclically to the next

available value.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

No comments

Silvercrest LT 710 User Manual Page 17