Silvercrest SHBS 5 A1 User Manual download pdf (Page 15)

SHBS 5 A1

Beard trimmer attachment

NOTE

►

Comb the beard in the direction of growth to remove any knots.

► Start by setting the comb attachment

to a longer length and reduce this in stages while

cutting the hair.

► Please note that the corresponding cut length will only be achieved if the slide switch

set to position 3 and the appliance is being held at right angles to the skin surface.

♦ Cut the beard against the beard growth direction (upwards from chin to ear). Trim ﬁ rst one

side and then other.

♦ Use the beard trimmer attachment

without the comb attachment

to cut the beard very

short or to add shape or trim a moustache.

♦ You can use the slide switch

to ﬁ nely adjust the cut length in three steps.

Precision trimmer attachment

♦ Use the precision trimmer attachment

to add shape to a moustache, mutton chops, sideburns

or eyebrows.

♦ Lay the edge of the precision trimmer attachment

at the required level of the hair growth

and move the appliance downwards.

Ear/nose hair trimmer attachment

♦ Use the ear/nose hair trimmer

if you want to remove ear or nose hair.

♦ Guide the metal end of the ear/nose hair trimmer attachment

slowly into the nostril or ear.

♦ Move the appliance slowly in a circular motion to cut the hair.

Shaver attachment

♦ Use the shaver attachment

for a dry shave.

♦ Hold the appliance at right angles to the skin surface and move it gently over your face.

♦ Shave in the opposite direction to the beard growth. In complicated areas, such as the chin,

pull the skin tight to achieve a better result.

IB_96126_SHBS5A1_LB4.indb 12IB_96126_SHBS5A1_LB4.indb 12 21.01.14 15:1621.01.14 15:16

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 129 130

No comments

Silvercrest SHBS 5 A1 User Manual Page 15