Silvercrest SE 32 A1 Service Manual download pdf (Page 12)

English

10 Silvercrest SCAW 5.00 A1

Charger

• Only connect the charger to the mains power supply if the voltage stated

on the rating plate complies with the voltage of your mains socket (the rat-

ing plate is attached to the underside of the charger). Incorrect voltage can

cause irreparable damage to the charger and the battery.

• To completely disconnect the charger from the mains power supply, al-

ways remove the mains plug from the mains socket. For this reason the

charger should be positioned so that direct and unobstructed access to the

mains socket is ensured and the mains plug can be immediately pulled out

in an emergency.

• To prevent the risk of fire, always disconnect the mains plug from the

mains socket if a battery is not being charged.

• For safety reasons disconnect the charger from the mains socket if you

are absent for a prolonged period of time and also if there is the risk of a

thunderstorm.

• Ensure that

− air can always circulate freely around the charger (do not place the

charger on a thick carpet or a bed, and always leave at least 10 cm

clearance on all sides).

− contact with sprayed and dripping water and corrosive liquids is pre-

vented and the charger is never operated near water; in particular it

should never be immersed (do not place any objects filled with liquids

such as vases or drinks on or near the charger).

− the charger is not subjected to any extreme temperature fluctuations,

as this may result in moisture caused by condensation and therefore a

short circuit.

− the charger is never subjected to excessive shocks and vibrations.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 109 110

No comments

Silvercrest SE 32 A1 Service Manual Page 12