Silvercrest CDV-710 Specifications download pdf (Page 13)

Deutsch

English

8 Installation

8.1 Installing the device

Note:

Please observe the following safety instructions for the connection of the device:

 Read the entire installation section before connecting the device.

 Disconnect the negative pole of the vehicle battery for the duration of the installation.

 Observe the safety instructions by the vehicle manufacturer during this task.

 If you need to drill holes for the installation, make sure that no parts of the vehicle are

damaged.

 The cross section of the positive and negative cable may not be less than 2.5 mm².

 Do not connect any of the vehicle’s plugs and cables to the radio unless you have the

appropriate specialised knowledge of this process!

 Only use the supplied cable to connect the device.

 Depending on the build of your vehicle, the installation may deviate from this description.

 We do not assume any liability for damages caused by faulty installations or connections,

nor any subsequent damages.

Note:

We recommend that you have the device installed by a specialised company. Then you will

have created the prerequisites for a problem-free functioning of the device. If at any point

during the installation you are unsure that you can correctly connect the device by yourself,

contact a specialist. A faulty installation may cause damages to the device and the vehicle

electronics.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 78 79

No comments

Silvercrest CDV-710 Specifications Page 13