Silvercrest Dynamo Torch User Manual download pdf

- 1 -

Dynamo Stand Flashlight

Operating and Safety Instructions

10 - 15 m

50 000 h, 5 x 10 000 mcd

Version v2.15

IAN 61890

Safety Instructions

Before you use this device for the first time,

please read the following notes in this manual

and heed all warnings, even if you are familiar

with handling electronic devices. Keep this

manual safe for future reference. If you sell the

device or pass it on, it is essential you hand over

this manual also.

LED Radiation! Avoid harm to the eyes!

Never look into the LED beam. If you notice

any eye damage, consult a physician.

Never use any optical devices such as a lens

to look directly into the LED beam.

Electrical appliances do not belong in the

hands of children. Do not allow children to

use electrical devices when not under

supervision. Children may not comprehend

the presence of potential risks. Keep the

packaging away from children too as there is

danger of suffocation.

If smoke, unusual noises or smells are

noticed, power off the device immediately.

Do not breath in any smoke originating from

a device fire. In these cases the device

should not be used further and should be

inspected by authorized service personnel.

Make sure that the housings of the Dynamo

Stand Flashlight, of the charger and of the

car adapter do not become damaged. Stop

using the flashlight immediately if you find

any cables damaged.

The supplied devices do not contain any

parts that require user maintenance. Never

open the housings of the devices.

The supplied charger WJB-Y35120200D and

the supplied car charger must be used to

recharge the built-in battery of the Dynamo

Stand Flashlight only. The charger must not

be used for continuous power supply. Never

connect the charger to other devices. Only

use the supplied charger or the supplied car

adapter to recharge the built-in battery of

your Dynamo Stand Flashlight.

This Dynamo Stand Flashlight has not been

designed for use on vehicles. It must not be

used as a replacement for a bicycle or

motorbike headlamp.

Always make sure that:

 no direct heat sources (e.g. heating) can affect

the device;

 no direct sunlight or bright artificial light reaches

the device;

 contact with sprayed and dripping water and

abrasive liquids must be avoided and the

device should never be operated near water. It

must especially never be immersed.

 the device is not subject to excessive shocks

and vibrations;

Intended Use

The Dynamo Stand Flashlight can be used as a

mobile flashlight for hobbies, leisure or camping.

Thanks to the charging function via the dynamo

crank you may use the flashlight anytime without

the need of any external power supply. The

supplied charger allows you to recharge the built-

in battery when a wall outlet is available. And the

car adapter lets you recharge the battery from

your vehicle. The flashlight can be placed upright

on its base and the magnetic side of its housing

allows it to be fixed to a metal surface. The

flashlight head can be turned through 180°.

This flashlight is not destined for commercial use.

The device fulfils all that relates to CE

Conformity, relevant norms and standards. Any

modifications to the equipment other than

recommended changes by the manufacturer may

result in these directives no longer being met.

Description

The items in the figure have the following

meaning:

[1] Dynamo Stand Flashlight

[2] Charger

[3] Car adapter (for 12V car battery)

[4] Rotating flashlight head

[5] On/Off pushbutton

[6] Magnetic surface

[7] Dynamo crank

[8] Charging indicator

[9] Indicator for full battery

[10] Receptacle for charger or car adapter

Technical Specifications

Dynamo Stand Flashlight

Lamps: 5 LEDs

Rechargeable

battery: Rechargeable NiMH battery

4.8V / 500 mAh

Dimensions: 21,7 x 9,4 x 8,8 cm

(L x W x H)

Weight: 410 g

Charger

Input voltage: 230V AC, 50 Hz

Output voltage: 12 V , 200 mA

Weight: 186 g

Car adapter

Operating voltage: 12 V

Fuse: 250 V / 2 A fast

Weight: 30 g

Getting Started

The Dynamo Stand Flashlight features a built-in

rechargeable battery. You can recharge it by

turning the dynamo crank in order to have the

flashlight immediately ready for use at any time.

Optionally you can recharge the built-in battery

with the supplied charger or the supplied car

adapter.

In order for the built-in rechargeable battery to

develop its full capacity, first execute an

extended charging cycle three times. To do this,

charge the battery for 16 hours and then fully

discharge it by using the flashlight. Repeat this

extended charging cycle at least two more times.

Charging via the Dynamo Crank

 Fold-out the dynamo crank [7].

 Turn the dynamo crank in any direction. In

order to obtain optimum charging, turn the

crank at a constant speed. During charging the

charge indicator [8] will light red.

Recharging the battery with the dynamo

crank can take a long time. You can stop

the charging process at any time.

The flashlight endurance varies depending

on the crank rotation time and the number

of LEDs switched on:

1 min. crank rotation =

max. 30 min. of light (1 LED)

max. 25 min. of light (3 LEDs)

max. 20 min. of light (5 LEDs)

Charging via the Charger

 Plug the small plug of the charger [2] into the

receptacle [10] of the dynamo flashlight.

 Plug the charger [2] into a wall outlet. During

charging the charge indicator [8] will light red.

 A full charging cycle for a completely

discharged battery takes at least 5 hours. The

charging process is completed when the

indicator [9] lights green. The Dynamo Stand

Flashlight is again ready for use. Then unplug

the charger [2] from the wall outlet.

Charging via the Car Adapter

Make sure that your vehicle has a 12V

battery. Never connect the car adapter to a

24V battery.

 Plug the small plug of the car adapter [3] into

the receptacle [10] of the dynamo flashlight.

 Then connect the car adapter [3] to a suitable

cigarette lighter in your car. During charging the

charge indicator [8] will light red.

 A full charging cycle for a completely

discharged battery takes at least 5 hours. The

charging process is completed when the

indicator [9] lights green. The Dynamo Stand

Flashlight is again ready for use. Then unplug

the car adapter [3] from the cigarette lighter.

Replacing the Fuse from the Car Adapter

The car adapter [3] has a small fuse. If the

charging indicator [8] suddenly stops lighting

when recharging the battery with the car adapter,

the fuse may be defective. Proceed as follows to

replace the fuse:

 Rotate the front cover counter-clockwise and

remove it from the car adapter.

 Remove the fuse. If required, replace the fuse

by a new one of the same type. Use a fast fuse

for 250 V / 2 A.

Normally, a defective fuse can be identified

by a broken wire inside the glass body.

Powering the Dynamo Stand Flashlight

On/Off

The Dynamo Stand Flashlight supports different

operating modes. This allows you to select

different levels of brightness. Press the On/Off

pushbutton [5] multiple times to toggle between

the following:

 1 LED on

 3 LEDs on

 All LEDs on

 Flashlight off

LED off

LED on

Press the On/Off pushbutton [5] once again to

toggle start the above cycle from the beginning.

The more LEDs you switch on, the faster the

built-in battery of your Dynamo Stand

Flashlight will discharge.

Cleaning

To clean the flashlight use a dry cloth. Never use

any solvents or cleaners that may damage the

plastic housing. Make sure that no liquid gets into

the housing. When very dirty, use a slightly

dampened cloth.

Disposal of Old Devices

Devices marked with this symbol are

subject to the European Directive

2002/96/EC. All electric and electronic

devices must be disposed of separately

from household waste at established bodies.

Avoid hazards to the environment and dangers to

your personal health by disposing of the device

properly. For further information about proper

disposal, contact your local government or

disposal bodies.

The built-in rechargeable battery cannot be

removed for disposal.

Declaration of Conformity

Targa GmbH, Lange Wende 41,

59494 Soest, Germany, declares that

this product complies with the basic

and other relevant requirements as well as with

the EMC Directive 2004/108/EC.

Warranty Information

The guarantee period is for 3 years as of date of

purchase. For any guarantee claims, please have

your proof of purchase ready, and phone our

hotline:

TARGA GmbH

Postfach 22 44

D-59482 Soest

Germany

Phone: 0207-3650744

TARGA GmbH

Postfach 22 44

D-59482 Soest

Germany

Phone: 01-2421583

Summary of Contents

Page 1

- 1 - Dynamo Stand Flashlight Operating and Safety Instructions 10 - 15 m 50 000 h, 5 x 10 000 mcd Version v2.15 IAN 61890 Safety Ins

Silvercrest Dynamo Torch User Manual

Browse online or download User Manual for Lighting Silvercrest Dynamo Torch. Silvercrest Dynamo Torch User Manual

Summary of Contents

More documents for Lighting Silvercrest Dynamo Torch

Comments to this Manuals

Silvercrest Dynamo Torch User Manual

Browse online or download User Manual for Lighting Silvercrest Dynamo Torch. Silvercrest Dynamo Torch User Manual

Summary of Contents

More documents for Lighting Silvercrest Dynamo Torch

Comments to this Manuals

Related products and manuals for Lighting Silvercrest Dynamo Torch